onetexasoldman
10-01-2010, 12:56 PM
Just finished carving a board and starting another and now when it is suppose to check the bit (which hasn't been changed) the sensing arm doesn't come all the way out for the bit to hit it. The bit goes all the way down missing it.
I have checked to see if anything is blocking from the bit going all the way over but can't find anything and it seems to be smooth. Now if I push it over (manually) all the way when it is checking the machine runs fine. So for some reason it's just not going all the way over.
I have checked to see if anything is blocking from the bit going all the way over but can't find anything and it seems to be smooth. Now if I push it over (manually) all the way when it is checking the machine runs fine. So for some reason it's just not going all the way over.