lhanner
09-13-2010, 06:14 PM
I have changed out bearing several time on my machine, and every time it did not help. Here I am again changing the bearing again. Just to please the techs. No criticism intended. I for one think they are better then most techs I have dialed with. Anyway I always had to heat up the bearing to get them off, mainly because of the Philip head striping out. I would like to try something different this time around, I have attached picture for your viewing pleasure. I would like to use Allen head screws this time. The question is, because the Allen head sticks out where as the Philip head dose not. Anyone think this would be a problem. As always I appreciate any and all feed back.