Digitalwoodshop
09-07-2010, 07:51 PM
I am still running 1.153 so this may already be done....
I would like to see the 1/4 inch bit be added to the Cut Path Selection of Bits.... I am asking because I believe the 1/4 inch bit will cut cut in first gear. I don't like the 2 speed 1/8 inch cut path. I want to use the 1/8 inch cut path bit but assign the 1/4 just to control the speed.....
OR.... Just give us a FEED RATE selection.... Now we Compensate by taking .4 depth cuts on hard wood that will SNAP the $40.00 Bit taking a full depth cut when it shifts into 2nd gear....
OK... Down loaded 1.171 and checked and no 1/4 inch bit in the cut path..... Sure I could have just l@@Ked at the update notes first....... Did read them later...
Thanks,
AL
I would like to see the 1/4 inch bit be added to the Cut Path Selection of Bits.... I am asking because I believe the 1/4 inch bit will cut cut in first gear. I don't like the 2 speed 1/8 inch cut path. I want to use the 1/8 inch cut path bit but assign the 1/4 just to control the speed.....
OR.... Just give us a FEED RATE selection.... Now we Compensate by taking .4 depth cuts on hard wood that will SNAP the $40.00 Bit taking a full depth cut when it shifts into 2nd gear....
OK... Down loaded 1.171 and checked and no 1/4 inch bit in the cut path..... Sure I could have just l@@Ked at the update notes first....... Did read them later...
Thanks,
AL