View Full Version : error detection
milestone mike
09-06-2010, 04:12 PM
I got an error 400 edge detection error. I vaccuumed it and blew it all out but still got it, any ideas what to try next???
mike
unitedcases
09-06-2010, 04:54 PM
Check your upper rollers. On the keypad side are the sensors and sometimes sawdust will get jammed up in there. Usually you can just loosen the screws a little and then blow or vaccuum them out.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.