Edge Routing

[chebytrk]

I have a project that I've already carved and wonder if I can still run it back in thru the CW and route the outside edges on it. Would I have to tape up everything in the center to cover it all up? Since I don't have a router, just wondered if I could run it thru the CW once more. Thanks......

[dbfletcher]

Assuming you still have enought material on the edges for the rollers to ride on, yes you should be ok. I normally just run a strip of masking tape down the middle and where the machine measures the width at the start of the project. You may not need to, but something i seem to have trouble with the board sensor when I dont.