PDA

View Full Version : Carvetight



jaroot
07-21-2010, 08:57 AM
Well we got our Carvetight and got it installed. I did a test carve last night and I'm very pleased. I wasn't very careful about my pattern selection and when the carve was complete I was shocked at the poor quality of the carve. But after reexamining the pattern I found that the machine had faithfully reproduced the less than perfect pattern. You can see pictures of the carve and the pattern in my blog.

Icutone2
07-22-2010, 10:37 AM
Like they say "trash in trash out" I bet you will look closer to it next time.
Lee