View Full Version : Z Stalls
gshinkel
07-10-2010, 12:15 PM
After installing the Carvetight system I am having Z Stalls, and it drives the bit deep into the board. What do I need to look at?:(
Digitalwoodshop
07-10-2010, 01:52 PM
Bearing not installed correctly.
Z Belt not installed correct
Screws to Z Motor not right, motor bound up.
Plug to Z Motor loose
Flat Ribbon FSC Cable loose or at an angle.
Beoken wire in the FSC cable.
Sawdust in the Z Belt.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.