toymaker
06-30-2010, 03:23 PM
It seems that there are a lot of these for sale these days. Although I like the machine, I just haven't used it as much as I thought I would. This one is one of the original models from 2006. 4 years old with very few carve hours on it. The machine still has the original box it was bought in; it comes with a scanning probe, the full set of Carvewright bits (never used), and "the Rock" spindle upgrade. The machine has the upgraded z-pack assembly and a brand new board sensor. I have never had any major problems with the machine and it has never been sent in for repairs. Any and all problems were user error. The Flexshaft has been taken well care of and lubed on a regular basis.
Also included is the printed out manuals for the machine and software, a set of replacement sandpaper traction belts, all of the Tips and Tricks from years past, and all the important notes and posts I have printed out from the beginning. There will also be a couple packets of molly grease (Crane Cam) that I have used to keep the flex shaft lubed.
Total Cut Motor Time 78hrs 27min
Total Power On Time 2158hrs 15min
Total Servoing Time 93hrs 34min
Total Scanning Time 10hrs 59min
I am asking $800 for the whole setup and buyer will pay for shipping (calculate shipping from zip code 83854).
Also included is the printed out manuals for the machine and software, a set of replacement sandpaper traction belts, all of the Tips and Tricks from years past, and all the important notes and posts I have printed out from the beginning. There will also be a couple packets of molly grease (Crane Cam) that I have used to keep the flex shaft lubed.
Total Cut Motor Time 78hrs 27min
Total Power On Time 2158hrs 15min
Total Servoing Time 93hrs 34min
Total Scanning Time 10hrs 59min
I am asking $800 for the whole setup and buyer will pay for shipping (calculate shipping from zip code 83854).