PDA

View Full Version : Epoxy resin question



sweliver
06-15-2010, 10:44 PM
Is it possible to carve a sheet of epoxy resin without damaging the CW? Just the resin - no fiberglass.

sw

spalted
06-16-2010, 06:26 AM
I think it's going to depend on the epoxy. There is a huge variation in epoxy characteristics and many other none epoxy products get thrown in under the generic term of epoxy.
But my first gut feeling is that it is going to tend to melt not machine clean. But that assumption only based on cast epoxy I have used in the past.