unknown error 59

[myshop1044]

I just got an unknown error 59 while compiling a project to my flash card. It stated I should notify LHR for a fix. Never saw this one before.

Myshop1044

[dbfletcher]

Thats cuz it is unknown!!! j/k

See if this thread helps...

http://forum.carvewright.com/showthread.php?t=13232&highlight=unknown+error

[myshop1044]

Thanks db for the link.
I read it all and starting hideing each carving and saving it until it worked, then I started putting them back on until it failed. I notice that 1 of my 1/16" v bit carvings had the max pass depth box checked off with .062 in it. what is "max pass depth "? I may have filled it in by mistake, don't know.

Well back to the test carve again

[AskBud]

Thanks db for the link.
I read it all and starting hideing each carving and saving it until it worked, then I started putting them back on until it failed. I notice that 1 of my 1/16" v bit carvings had the max pass depth box checked off with .062 in it. what is "max pass depth "? I may have filled it in by mistake, don't know.

Well back to the test carve again
Max Pass Depth, is used to limit the depth allowed on any given pass of the cutter, while performing the operation involved. It is not an option in every Designer bit application.
AskBud