Stupid Question about Bits

[wgrecco]

To all,

I have a stupid question... I have the extra full bit set and finally got around to taking off all the adaptors so I can now use them with my CT. Heres the ?....

How do I know which bit is which?? For example, which is the V60? V90? etc.... Is there some diagram out there that is labeled with the pictures for each one?

I know I am a newbie at this but geez! LOL...

Thanks for all the anticipated help!

Wayne

[Jeff_Birt]

Look on page 42 (43 in the PDF) of the manual: http://carvewright.com/images/service/Manuals/CarveWright_manual.pdf .

[wizer]

well the easiest way to tell the difference between the 60 and 90 would be to hold them up to a set square. The 90 will match the angle. Or, easier, the 60 degree is a 'pointier' angle.

[wgrecco]

Thanks both of you for the quick replies and helpful info! Just what i was looking for!!

Wayne