Jimmygee
11-11-2006, 04:01 PM
Hello All,
I know the people from LHR posted hoe to do fret work on the forum. I can not find it. Could anyone direct me to it. And does anyone know if you can scan in a scroll saw type pattern and use it with the CW? And since I have you on the line, I have used in some of my work the 1/4 inch round over. I use it at the full depth of the wood, proble is it works great on the right and top, pretty good on the bottom, but it leaves about 1/16 of an inch of flat woo under the round over on the left side. I then have to go cut it off. Any suggestions. There's my novel of questions.
Thanks
Jimmy Gee
I know the people from LHR posted hoe to do fret work on the forum. I can not find it. Could anyone direct me to it. And does anyone know if you can scan in a scroll saw type pattern and use it with the CW? And since I have you on the line, I have used in some of my work the 1/4 inch round over. I use it at the full depth of the wood, proble is it works great on the right and top, pretty good on the bottom, but it leaves about 1/16 of an inch of flat woo under the round over on the left side. I then have to go cut it off. Any suggestions. There's my novel of questions.
Thanks
Jimmy Gee