TurtleCove
05-20-2010, 09:15 PM
I did a search up here on "Cut Motor", but got a message that the search term was too short.
In any event, I haven't used my machine in about 4 months.
It goes thru the drill of asking me to insert each bit, but as I recall, after I insert a bit, and tell it 'ok', it should spin the bit a little, and then home it.
Well, it never spins it. And so, when it begins cutting, the bit's not spinning. The machine acts like it thinks the bit is cutting, but it's not, cuz it's not even spinning. I did get a "check cut motor" message, and selected continue.
Since I can't search for "cut motor", can you all help me trouble shoot this? Not sure why this would crop up, just from the machine sitting for a few months.
In any event, I haven't used my machine in about 4 months.
It goes thru the drill of asking me to insert each bit, but as I recall, after I insert a bit, and tell it 'ok', it should spin the bit a little, and then home it.
Well, it never spins it. And so, when it begins cutting, the bit's not spinning. The machine acts like it thinks the bit is cutting, but it's not, cuz it's not even spinning. I did get a "check cut motor" message, and selected continue.
Since I can't search for "cut motor", can you all help me trouble shoot this? Not sure why this would crop up, just from the machine sitting for a few months.