After upgrading z bundle, z truck and rock chuck

[alan.galbraith]

I am not able to get to the main menu on the machine, it comes up in the accessory menu, scan area. cannot get to projects.

[dbfletcher]

Take a look at this thread...

http://forum.carvewright.com/showthread.php?t=4809&highlight=menu+scan+area

Doug Fletcher

[alan.galbraith]

That resolve my problem. Thanks for your quick response.

[Digitalwoodshop]

Good Job !!!!

Al:)

[alan.galbraith]

during the upgrade, skinned my knuckles, broke the 1/8" cutoff bit, broke the spindle tool that came with the rock chuck. I had tightened the rock chuck bit older too tight the first time. had to use a pipe wrench to get it off so I could use a t-handle hex wrench to go up thru to pop out the broken spindle tool. They should change the name from Murphy's law to the Galbraith's law.

Oh well, at least I'm carving again.