need help

[bernie]

can anyone tell me where to get cat porgram for eit my pic so can carv them good bernie

[c6craig]

huh? Are you looking for a cat pattern? :confused:

Craig

[AskBud]

can anyone tell me where to get cat porgram for eit my pic so can carv them good bernie

I think you are asking about Design Editor. It cost $199 by its self, but for $299 you also get the Scanning Probe, which is well worth the cost.
AskBud

Check out my "Download" section below for lots of helps.

[bernie]

no i am not looking for a cat patten like to get something to trun a pic in to negative i called carvwright today and said to get a cat to do that bernie

[atauer]

It sounds like the technician may have been confused with what you were wanting.

You are simply wanting to make a negative of a pattern, correct?

If so, you can use the "Invert" feature within the software to invert patterns. This feature will invert the entire pattern.

[AskBud]

no i am not looking for a cat patten like to get something to trun a pic in to negative i called carvwright today and said to get a cat to do that bernie

I think you are looking for this, I'm not sure by your wording.

The attached is just using PAINT to INVERT to a Negative.

As Atauer said, you may also just invert the pattern after you accept it in the design.
AskBud

[bernie]

I think you are looking for this, I'm not sure by your wording.

The attached is just using PAINT to INVERT to a Negative.

As Atauer said, you may also just invert the pattern after you accept it in the design.
AskBud

yes thats it how do i get that bernie

[AskBud]

yes thats it how do i get that bernie

I send you a Private Message.
AskBud

[Digitalwoodshop]

Using a photo to sketch program.

Have not tried it with the CW but it works great with the Laser.

AL

[Cabinetdesigner]

Using a photo to sketch program.

Have not tried it with the CW but it works great with the Laser.

AL

that many buds can be intoxicating!:p