stanv77
05-05-2010, 08:43 PM
Hello everyone
I am having a little problem when I try to cut out a project. I have never had this trouble before. When I cut out a project it seem to move the length of the project about 1/16 for every pass. Causing a stepping effect on the edge of the project. What do I do to fix thid problem?
I am having a little problem when I try to cut out a project. I have never had this trouble before. When I cut out a project it seem to move the length of the project about 1/16 for every pass. Causing a stepping effect on the edge of the project. What do I do to fix thid problem?