View Full Version : Tracking error 320
racer
05-02-2010, 09:31 PM
Running 1.163 Have ran this mpc a lot of times befor with no error .using tap on roller side. board is 12X4X.505 and flat . if i change the mpc to 3/4 and the wood to 3/4 all is ok . this only happens on 1/2. see my MPC Thank's Racer
1st Problem in 16 mounths Thanks Racer
AskBud
05-02-2010, 10:10 PM
Running 1.163 Have ran this mpc a lot of times befor with no error .using tap on roller side. board is 12X4X.505 and flat . if i change the mpc to 3/4 and the wood to 3/4 all is ok . this only happens on 1/2. see my MPC Thank's Racer
1st Problem in 16 mounths Thanks Racer
If the board is truly .5 or over, I would blow out the Head rollers. The sensors may not be clean enough to activate with this thin stock.
AskBud
racer
05-03-2010, 09:15 PM
Thanks for the help recleaned all but is still not taking .505 stock I have to get above .600 befor it works i have ran this same buckle in this sled 6 or 7 times first time i have tried to run with new soft ware update do you think it can be the 1.163 ??? Racer
AskBud
05-03-2010, 09:26 PM
Thanks for the help recleaned all but is still not taking .505 stock I have to get above .600 befor it works i have ran this same buckle in this sled 6 or 7 times first time i have tried to run with new soft ware update do you think it can be the 1.163 ??? Racer
What happens when you use the "Measure Option" on your sled? Does it abort? If so, contact LHR with a 1.163 software problem.
AskBud
racer
05-03-2010, 09:48 PM
Thanks Bud I will try that about 6:30 am Good Night its been a long day .spent most of the day looking for a job. Racer
c6craig
05-04-2010, 04:39 AM
Racer,
Good luck on your job search, I hope today brings you the right opportunity.:cool:
Craig
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.