View Full Version : X axis error 293
pbethard
04-24-2010, 12:58 PM
I just replaced a X termination board and now I am getting a error message X axis 293. Can anyone tell me what to do?
Digitalwoodshop
04-24-2010, 01:19 PM
Look for a loose plug or a plug only catching 2 of 3 contacts.
Why did you replace it? C1 Broken?
Change back to old board and see if anything changes.
X Drive Motor Plug. White Wire to the outside.
The Cover for the X Drive plug just sits on the circuit board and can be pulled off and replaced 180 degrees out making the white wire toward the circuit board and a non working X Drive.
OR the X Term Board is BAD.... I got a bad one once.
AL
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.