X axis error 293

[pbethard]

I just replaced a X termination board and now I am getting a error message X axis 293. Can anyone tell me what to do?

[Digitalwoodshop]

Look for a loose plug or a plug only catching 2 of 3 contacts.

Why did you replace it? C1 Broken?

Change back to old board and see if anything changes.

X Drive Motor Plug. White Wire to the outside.

The Cover for the X Drive plug just sits on the circuit board and can be pulled off and replaced 180 degrees out making the white wire toward the circuit board and a non working X Drive.

OR the X Term Board is BAD.... I got a bad one once.
AL