View Full Version : Freezes at Stay Under Roller Prompt
Woodlegend
04-13-2010, 07:05 AM
I was told problem was with Memory card. I replaced memory card and when I begin project I am only able to get to the stay under roller prompt 1 or 2. When I hit the keypad for either 1 or 2 nothing happens. I tried hitting arrows and the screen appears frozen. I tried another project and the same problem occurs.
Any suggestions?
www.go3d.us
04-13-2010, 12:46 PM
Hi, have you tried format the card and up date firmware on the card?
Woodlegend
04-13-2010, 03:04 PM
Thanks for everyones help. I found a slight tear in the keypad cable that probably is the cause of the frozen keypad. Will replace
Icutone2
04-13-2010, 03:05 PM
Dry lube all 4 posts go up and down a few tines and blow out the clutch handle relube 4 posts. That works for me all the time Hope it helps!
Lee
Icutone2
04-13-2010, 03:06 PM
sorry wrong place
Lee
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.