Power on

[unitedcases]

I turn the machine on and it goes to "Carvewright woodworking machine" and thats as far as it goes. I replaced the controller in it about 150 hours ago. I already reformatted both memory cards. What does everyone think?

[DocWheeler]

unitedcases,

Sounds like the machine can't read the card, do you have another card to try? Can you see if a pin is bent in the socket? Just my thoughts.

[unitedcases]

I actually did think of that as well. I took the bottom panel off just to check the controller and associated plugs but to no avail. I have cleaned it and it just wont turn on. I took about a week off from running it and I just dont understand. Oh but yes, I did check the card and the pins.