View Full Version : Muffler Bag

Aaron B
10-06-2006, 09:13 AM
Does anyone else have of a problem of it coming out? I have noticed mine in the floor the last few times after a project.


10-06-2006, 10:18 AM

With time, one can expect that bag to come loose as it's not all that tight a fit to begin with, but a one wrap of masking tape (or?) will take care of that problem quickly. That's not a muffler (and if it were, it doesn't do much of a job of it), but is a chip dust filter which is why there is enough pressure in it to force it off if the fit isn't tight when the machine is operating.


Aaron B
10-06-2006, 09:44 PM
Thanks Bob, I will put something around it to tighten it up. I have the CW hooked up to my DC but when that bag blows off some chips still shoot out the back, so I will make it tighter.

10-06-2006, 09:51 PM
I suspect that's happened to just about everyone, Aaron. But if it's welded on, it makes it a bit unhandy sometimes to do things like put the back tray up, etc.


10-16-2006, 08:12 PM
I put a dart board on the wall opposite mine. After several runs I was able to get a 'bulls-eye' consistantly!

...POP! .. 500 Points+++! :shock:

Maybe a new accessory item for the CW? :roll:

Well....something to do while it's carving... :lol: