PDA

View Full Version : My First


Sshanks
04-01-2010, 02:33 PM
Finally completed my first carved project. Very excited. So far I am amazed with the CW.
henry1
04-01-2010, 02:35 PM
You done good keep it up and use the rock chuck now alot better and quieter
CarverJerry
04-01-2010, 02:43 PM
Great looking project, nice job.....I agree henry1, go with a rock....
c6craig
04-01-2010, 02:44 PM
Very nice! Boxes are my favorite and that one is very nicely done!

Craig
Icutone2
04-01-2010, 03:12 PM
Great Job! Looks really sharp! Thanks for showing it.
Lee
Kenm810
04-01-2010, 04:34 PM
Great looking Project for a First Carving!!
Thanks for Sharing your Photos :grin:
TerryT
04-01-2010, 05:03 PM
That is very nice indeed. A lot better than my first project.
Nighthawk12
04-01-2010, 05:32 PM
Very nice your very skilled. I've had my CC for close to three years and it still amazes me the quality keeps getting better with every upgrade.


Jim
b.sumner47
04-01-2010, 05:43 PM
well done,It looks like you put some time into your work. .Nice, Welcome Aboard. Capt Barry
TIMCOSBY
04-01-2010, 11:41 PM
for such a great project to be your first project. welcome to the forum.
www.go3d.us
04-02-2010, 01:54 PM
Nice looking box, well done.
Ropdoc
04-05-2010, 01:49 PM
Finally completed my first carved project. Very excited. So far I am amazed with the CW.


Hello,

I want to make a box for my wife. But I can not figure out how you make the curved surface on the sides. I am using a feature that has the rolls in it but it wont let me do just one roll. Please tell me your secret.

Thank you,
Dave
Kenm810
04-05-2010, 02:08 PM
This Might be what your looking for :wink:

A Carved Region and a Select Surface Setting,
than add your Text and Graphics Additive
Ropdoc
04-06-2010, 09:07 AM
Yes that is what I am using and that is the answer to my question. Andd that is how I set it up but it always shows me 2 bumps. I told it to scale to fit. I will trust in your knowledge and do it again.

Thank you so much for responding.
Dave
AskBud
04-06-2010, 09:17 AM
Yes that is what I am using and that is the answer to my question. Andd that is how I set it up but it always shows me 2 bumps. I told it to scale to fit. I will trust in your knowledge and do it again.

Thank you so much for responding.
Dave

If you attach your MPC, we might be better able to see your problem area. Lots of times, a picture is better than a thousand words.
AskBud