scamp62
03-23-2010, 11:30 PM
I have been running my CW without a hick up for some time now , but up dated the software today, and did a carve, the carve was fine……BUT then it went to rout out the project ! the CW asked for the cutting bit, I installed the bit, it did the tapping thing all looked well ! got the message that it was going to cut out the project, motor started up
And sat there spinning about 3/8” over the board and the belts ware ever so slowly moving. Let it do this for about 8 minutes and that’s all it did, so shut it down (will cut it out by hand) but anybody else have the problem ?……any fixes ?….is it the up date ?
Thank you gentlemen for any help !
And sat there spinning about 3/8” over the board and the belts ware ever so slowly moving. Let it do this for about 8 minutes and that’s all it did, so shut it down (will cut it out by hand) but anybody else have the problem ?……any fixes ?….is it the up date ?
Thank you gentlemen for any help !