View Full Version : Bit depth
Wilbur
03-20-2010, 01:48 PM
How do I set the bit depth to make more than one pass in order to not cut so deep that it stales out the Y axes.
Thanks
Wilbur
Digitalwoodshop
03-20-2010, 01:53 PM
When you assign a bit to a path the same window has a block at the bottom to set the depth of each cut.
AL
Wilbur
03-20-2010, 02:39 PM
Thanks a lot. I have never done this. I seen it but never though that it was for that.
Wilbur
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.