View Full Version : Z-Axis stall
Can anyone tell me what a "Z-Axis Stall 313" is? I was about 2 hours into a carve and the machine stopped and showed the message. Cleaned and lubed everything. Still getting it. Soon as I hie the start button.:mad:
AskBud
03-19-2010, 06:32 PM
Can anyone tell me what a "Z-Axis Stall 313" is? I was about 2 hours into a carve and the machine stopped and showed the message. Cleaned and lubed everything. Still getting it. Soon as I hie the start button.:mad:
The Z-Axis Stall pertain to the up & down movement of the carving head.
AskBud
jwblazek
04-16-2010, 11:17 AM
I have received this message as well and the fault was the flex cable housing pulled out of the motor! The screw that tightens the clamping arrangement or the tapped surface ( I will take it apart this afternoon) is stripped and consequently will not tighten
ruggybear
04-16-2010, 11:41 AM
Clean the Z rails with a nylon hard bristle brush. Make sure you do both sides and move the Z truck so you get the portion of the rail that is it covering up. This will remove any pitch or other debris that you can't see. Also works for Y axis stalls when you clean the Y rails.
This has worked for me.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.