View Full Version : Thread Size
dandrea
03-07-2010, 10:54 PM
Does anyone know what the thread is for the two holes on the inside of the door? I'm making a dust collector hood and need to use the holes to secure it in place.
Thanks
Dan
Icutone2
03-08-2010, 08:07 AM
The material is aluminum, you could tap it to almost any size you need.
It would be a through hole so put down some toweling on the sand belts to keep them clean. Just an idea for what it is worth.
Lee
Icutone2
03-08-2010, 08:08 AM
Forgot to say Welcome to the Forum!
Lee
dandrea
03-08-2010, 10:26 AM
There are two holes already there and threaded. Just wondered if anyone knows that thread size.
Icutone2, thanks for the welcome. I've been on here a while but I do more lurking than posting I guess! :D
Chief38
03-08-2010, 01:35 PM
but don't have unit available to check what it was. Some one posted it quite a while ago.
chkorte
03-08-2010, 01:46 PM
Does anyone know what the thread is for the two holes on the inside of the door? I'm making a dust collector hood and need to use the holes to secure it in place.
Thanks
Dan
I think those holes are 10/32. I was using them to hold my DC in place when I first installed it but soon tired of having to unscrew the bolts every time I needed to change the bit. I found that my DC stays in place just fine without being bolted down.
dandrea
03-08-2010, 02:05 PM
I tried 10/32, 8/32, 6/32. Its either 8/36 or M4. Another trip out for fasteners I think! :D
dandrea
03-08-2010, 07:00 PM
M4 if anyone wants to know.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.