eharsin21
02-28-2010, 12:10 PM
I am SOOOOOOOOOOOOO fed up with this piece of crap. I bought my machine 5 years ago. I have completed 6 projects in that time. I get so frustrated with "Close Door" "Board Sensor" and the spring arm not opening enough for the bit to hit it that I put up for a year or so and try it again.
So here we go again. I have replaced the board sensor, door sensor and lubricated the spring arm. It takes at least an hour EVERY new project to get things all aligned with the stars and moon. Last night I went thru all of this and finally got a 5 1/2 hr. board cut. Needing to cut on the opposite side, I tried again this morning. SAME OLD xxxxxx. It amazes me that you can have everything working properly, turn off the machine and within 5 minutes all of the sensors don't work again.
Enough ranting..............does anyone know if there is a way to bypass the "Door Sensor"? After an hour today I finally got it to start, but after 15 seconds the door sensor stoped the carve. I push the enter button and it will run again for 5-10 seconds and again it stops with the door sensor alert. I don't want to junk a 5 hour piece of work.
PLEASE HELP ME before I take a sledge hammer to this piece of chineese excellence.
Ernie H. :confused: :mrgreen:
So here we go again. I have replaced the board sensor, door sensor and lubricated the spring arm. It takes at least an hour EVERY new project to get things all aligned with the stars and moon. Last night I went thru all of this and finally got a 5 1/2 hr. board cut. Needing to cut on the opposite side, I tried again this morning. SAME OLD xxxxxx. It amazes me that you can have everything working properly, turn off the machine and within 5 minutes all of the sensors don't work again.
Enough ranting..............does anyone know if there is a way to bypass the "Door Sensor"? After an hour today I finally got it to start, but after 15 seconds the door sensor stoped the carve. I push the enter button and it will run again for 5-10 seconds and again it stops with the door sensor alert. I don't want to junk a 5 hour piece of work.
PLEASE HELP ME before I take a sledge hammer to this piece of chineese excellence.
Ernie H. :confused: :mrgreen: