mustang
02-25-2010, 08:28 PM
I am seriously thinking of selling my 2 year old compucarve. I had it sent back to LHR a year ago because it would not measure a board and if it did it stopped halfway into a carve. They replaced the z truck, new ribbon cable, new sandpaper belts and board sensor. I have used it a total of 80 hours and it has only 22 on it since going in and now it is giving me fits, z axis 238 error and x axis 248 and it is not measuring the board length correctly under rollers or not. I took it apart and checked all connections, wires, sensors[all test out ok] and everything is moving freely and easily. someone make me a reasonable offer shipped and it is yours, I have the original box and all papers to go with it. I live in western NY state.