the_engineers
02-23-2010, 07:36 PM
I'm having a problem getting one of my projects to carve. The workpiece is 12" x 12" x 1 5/8".
When I load the project the display informs me that the project file is based on a 12 x 12 workpiece. The CW then measures the board and comes up with 5.066" long x 12.005" wide.
However, if I simply have the CW measure the board (not in the project menu), it comes up with 12.019" long x 12.005" wide.
How can I fix this? I don't have a new piece and I've even covered this one with paper to prevent the ye from detecting defects. Is there a manual over-ride?
When I load the project the display informs me that the project file is based on a 12 x 12 workpiece. The CW then measures the board and comes up with 5.066" long x 12.005" wide.
However, if I simply have the CW measure the board (not in the project menu), it comes up with 12.019" long x 12.005" wide.
How can I fix this? I don't have a new piece and I've even covered this one with paper to prevent the ye from detecting defects. Is there a manual over-ride?