No Power

[Colleen_and_Mike]

Was in the middle of carve and then my machine went dead, no power at all, thought I had popped a breaker but no such luck, it's the machine. No power at all.

Will have to put in a call to CW tomorrow, but any idea's at what may have happened..

[rjustice]

Colleen_and_Mike,

First thing to do is check to make sure that the memory card didnt vibrate out.

Turn off the machine, take it out, put it back in, then turn the machine on again. If this doesnt make it power up you likely have the "L2 coil" problem on the power supply. Some have fixed it successfully, others opt to just purchase a new one.

Good luck!

Ron