outlining a pattern

[ScottS]

I can't seem to get a cutpath around the bear and the lightswitch cover. Can anyone help?These are patterns I found here in the forums.

Thanks ScottS

[Kenm810]

Scott,

Just Hightlight only the the Bear and Switch Plate Trees
to get your cut path around them. :wink:

[ScottS]

Ken Thanks I knew I just was not doing something right.
I do have another question. Why in my mpc does the bear switch plate not show the outline cutout on the back of the carving but It is appyed to the front?

Thanks for your help
ScottS

[ScottS]

I got It finally. It had the cutout hide. Thanks For your help Ken.Now to try the second cutout test. The 1st one had a little too big of holes and switch cutout. I tighten those up and added rear recess carves. I guess I'll run it and see.

ScottS

[Kenm810]

Just got back from some errands I had to do
before the Snow starts again the afternoon.
Glad to see see you got the cutouts working :wink:

[ScottS]

thanks Ken Its carving now and without the fireplace running.:-D Not suppost to get cold till Wednesday.:roll:

Thanks ScottS

[Freddie]

thanks for the info.