5twenty
02-20-2010, 03:45 AM
When I start carving a 2 sided carve will the machine tell me to turn the board over to cut the second side or is that a completely seperate carve? I don't see a way to upload only one side to the CarveWright machine so I'm presuming it takes only one file and after the first side is carved the machine will tell me to flip the board.
Also when I flip the board I do it so the same end of the board touches the brass roller for each side. right? i.e. if a hole was drilled that was directly over the brass roller it would also be directly over the brass roller after the board is flipped.
Thanks for all the help you guys have given me to get this far.
Also when I flip the board I do it so the same end of the board touches the brass roller for each side. right? i.e. if a hole was drilled that was directly over the brass roller it would also be directly over the brass roller after the board is flipped.
Thanks for all the help you guys have given me to get this far.