View Full Version : Jog to touch position
bowfingers
02-18-2010, 06:00 PM
I seem to have lost the” jog to touch” option when setting up a carving the machine just picks a spot and does it automatically. Is it possible to get this option back?
Thanks’
Denny
:confused:
Denny
If you go into the options area on the machine using the keypad you can enable jog to touch option.
bowfingers
02-18-2010, 06:19 PM
Thanks’ Dan!
I never thought of the options menu on the machine, I was looking in the software (DUH)
Denny
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.