hess
02-08-2010, 12:33 AM
I have a Delta 14 inch BS that seems to cut well for about 2 mos then I could not cut a line with it for not. Well over the weekend I was moving the shop around when the table for the saw lift right off into my hands
at 1st I though the bolt holding it on came out not so lucky seems thei so call HD saw has all Trunnions and they both just fell apart.
Delta is sending new ones thank you delta but they will be the same
Appears moving it by the table breaks these part they don't cost must less than 25 buck but are on BO for 2 months
So if you have a delta 28 276 careful when moving them
I would have to get up to 950 in grizzly before they are made out of Cast ion
BTW got it form Loews still under warranty they are NO help
at 1st I though the bolt holding it on came out not so lucky seems thei so call HD saw has all Trunnions and they both just fell apart.
Delta is sending new ones thank you delta but they will be the same
Appears moving it by the table breaks these part they don't cost must less than 25 buck but are on BO for 2 months
So if you have a delta 28 276 careful when moving them
I would have to get up to 950 in grizzly before they are made out of Cast ion
BTW got it form Loews still under warranty they are NO help