View Full Version : 1/8" Ballnose
Brian
01-11-2010, 11:36 AM
I have a design that I would like to cut with the 1/8" ball nose. Is that the same as the 1/8" bit which comes with the machine:confused:
Following is the design:
Kenm810
01-11-2010, 12:16 PM
Hi Brian,
The two bits that normally come with the CW -CC Machines
are the 1/16" Carving Bit and the 1/8" Cutting Bit.
I have a 1/8" Ball Nose Bit, but with an 1/8" shaft,
and is a after market all carbide bit that I bought from Sears
Ps. If you look around ,you can find them with a 1/4" shaft
hogiewan
01-12-2010, 08:05 AM
I bought a 1/8" ballnose from LHR
give them a call - if they have a bunch in stock, they'll sell you one. They are for some education kit and are recommended for soft woods only.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.