power outage during carve

[flamesrule]

Well i had a power outage at the house.I was doing a carve and was about 50% though.Is there anyway i can save this project as it is almost 4.5 hours long.

[Wilbur]

You can re-do the carve. If your machine measures the same it will start at the right point and go through the motion until it gets to where it stopped and take up from there. I have done this 4 different times and it all worked out fine.It is best if you haven't taken the board out but should not make a difference if the measurement is the same.

[RayTrek]

What works for me is in designer I put a carve region over the area I have done and set the depth to 0, the carve will start from the point at the end of that region.
Cheers ~ Ray

[flamesrule]

Thanks guys got it to work.Just did the air carve it still turned out good:)