View Full Version : Rounding a corner
jtsvstar1100
01-02-2010, 12:33 PM
Hi guys
I'm carving a rectangle 12" x 9" out of a board
that is 20" x 13.25".
Question is, how do I round the corners.
I used the rectangle tool and placed a carved region on it
that is .250 deep. I need to make the corners
1/4" radius.
Any help would be appreciated.
Thx Jeff
Chief
01-02-2010, 12:37 PM
Jeff,
If you have a router, after the carving is done, cut the board to size and use a handheld router. There will be less wear and tear on your Carvewright and the handheld is much faster. If you don't have a router, well, then you'll have to wait until somebody comes around that can answer your ?.
Chief
fwharris
01-02-2010, 12:39 PM
Jeff,
Did a search on "rounded corners" and there are a lot of posts on this..
http://forum.carvewright.com/search.php?searchid=996786
AskBud
01-02-2010, 05:03 PM
Here is a 8.07 MB AVI lesson on Rounded corners that may help you understand the concept. It may be use on a Carved area or Vector cut (it's your choice).
AskBud
http://www2.wcoil.com/~nharbison/CW-Rounded%20Corners%20and%20Cut%20Path.zip
Chief
01-02-2010, 05:53 PM
FW,
There's something wrong with your URL.
Chief
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.