Error Codes

[chebytrk]

Is there a list somewhere that shows all of the Error Codes? Went to use my CW today and at first I got Error 309. Turned off and back on again and this time I get Error Code 107. Haven't seen that one before. Anyone heard of it? Depresses cause I'm down....

[twiceretired]

Did a search and got this response. I havent seen a list of error codes, I think it was mentioned a while back that they seam to change with the soft ware changes.

http://forum.carvewright.com/showthread.php?t=13083&highlight=Error+Codes

[chebytrk]

Did a search and got this response. I havent seen a list of error codes, I think it was mentioned a while back that they seam to change with the soft ware changes.

http://forum.carvewright.com/showthread.php?t=13083&highlight=Error+Codes

Thanks........ got mine working again. Tried a different cutting bit and it worked fine after that. It's the stupid collar that I had on it. I took them all off. Hope they work good for me.. had problems without the collars on my Rock before. Couldn't set the bits in at the exact same spot each time and "Shanita" didn't like that.:D