Flipping trace

[LollyWood]

Hmmm...:confused:

Ok, I trace a pattern with the seg, line, arc tools. Get good connection at all points. Delete the pat. Set the cut out. (here's where I get stopped:rolleyes:)

I can flip the cut out L-R, but not top - bottom.
What am I missing. (Knowing me it's something pretty ez:roll:)

[Kenm810]

Hi Bernie,

After out-lining and tracing your pattern, try grouping the vector lines thens select all,
and flip everything before deleting your pattern.
The Vector lines should follow the out-line and pattern in the flip.

[LollyWood]

Ah-ha. Thanks Ken, that was the ticket.:D

Merry Christmas sir.

[Digitalwoodshop]

I was not able to make it flip..... I should try that trick....

I flipped each piece then re aligned them.

The Deer is the Development Logo used in newsletters.

Traced it by hand and assigned the 1/8 inch cut path bit to the Production Sign, used the V60 on the test carve.

Even the Realtor Logo I had to flip and move the lines and cuts.....

AL