PDA

View Full Version : Cut and Paste



sk8nmike
11-23-2009, 03:54 PM
OK, did I miss something in the instructions?

I made a scan of an object with the intention of remaking is with a broken section replaced. I used Control C and copy from the menu to copy an out lined section but could never get it to paste it back in and Paste never hilighted in the menu. What did I do wrong?

and yes this is with the Pattern editor software from CW..

mostlycold
11-24-2009, 03:57 PM
Try Control V to paste it back in.

mtylerfl
11-24-2009, 04:53 PM
OK, did I miss something in the instructions?

I made a scan of an object with the intention of remaking is with a broken section replaced. I used Control C and copy from the menu to copy an out lined section but could never get it to paste it back in and Paste never hilighted in the menu. What did I do wrong?

and yes this is with the Pattern editor software from CW..

If you are using the Pattern Editor, the Copy/Paste functions do not work, unfortunately.

Copy/Paste does work fine in Designer, however.