Neykok
11-22-2009, 11:39 PM
I'm building a display case for a buddy and he was asking if I can slope the shelves by 30*. After a great deal of playing, I was able to do it utilizing most tools in my workshop, however I am not by any means an expert on the CW if anything still a novice.
My question is this: Can the CW cut a 30* shelf from say a 1" stock with the underside of the shelf cut away. I understand that I would need to do the top first then flip the project, but I don't know how to begin, nor if the CW has that capability.
Any advice will great greatly appreciated.
My question is this: Can the CW cut a 30* shelf from say a 1" stock with the underside of the shelf cut away. I understand that I would need to do the top first then flip the project, but I don't know how to begin, nor if the CW has that capability.
Any advice will great greatly appreciated.