z axis stall error code 309????

[nagsheadbum293]

It started with a "clean board sensor", did that. Now i get to the flipper and it jerks and gives me a 306 z axis error???? Please help me before i go postal on this machine........

[Digitalwoodshop]

WOW.... Don't go postal..... First Post

Could be wood chips in the Z Motor belt cogs causing the problem.

Spent some time reading the forum and Tips and Tricks. This machine is not like a Table Saw, works great out of the box...

There are about a dozen Pilot Errors that you can make that will drive you nuts using the machine...

Reading Tips and Trick will tell you about things that are important to know... like: The 7 inch rule of wood, Cleaning the QC, Head stuck in the up position.

You need to use the " " in doing a search like "Bit Plate" or "Z Motor"

Welcome

Good Luck,

AL