View Full Version : Help Carves too deep
coyoteugly543
11-17-2009, 06:31 PM
Machine has been working good for 30 or 40 hours than all of a sudden it starts carving and just keeps going deep and deeper.
Digitalwoodshop
11-17-2009, 07:01 PM
Post 14..... NEW.... Is machine OLD?
DO you have the old Z or the new Z? Long cooling fins on the old Z. That is a classic problem with the old Z.
Bit loose in the bit holder... You need to Blue Lock Tite them EVEN NEW bits...
Picture 2 has text about something else but is a good shot of the 2 screws that hold the Truck. I had a loose truck and found the screws loose on the BELT.
Bad Encoder, Dirty Encoder, Encoder clear plastic loose on shaft of Z Motor.
Wood Chips in the Z Belt preventing a UP movement.
Board it tipping up only being under 1 roller?
Lots of reasons.... Tell us more....
AL
coyoteugly543
11-17-2009, 07:18 PM
The machine is almost 1 yr. old nothing but trouble since I had it. Got all new updates new berrings, rock chuck, truck that moves up and down, and it started working great and I was happy with it finally. that tonite I carved 4 different items out 1 good and 3 bad. It just started getting deeper and deeper. on a long carving it went all the way thru a 3/4 inch board. I have a dust collector on it and I keep it very clean and oiled.
Digitalwoodshop
11-18-2009, 08:32 AM
Order a new Z Motor and FSC Cable.
AL
coyoteugly543
11-21-2009, 09:27 AM
thank you all for the help got a Z Motor order
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.