How Do You Remove The Spindle

[ruffus]

HOW DOES ONE REMOVE THE DAM SPINDLE?:confused:

[Old Salt]

Bearings On Right Side On A Offset Shaft Turn Nuts On Back To Move Back And Fourth .

Ck Out Dpfs On Main Site

[AskBud]

HOW DOES ONE REMOVE THE DAM SPINDLE?:confused:

I think you are asking about removing the Flex Shaft from the Truck, so you may lube the Flex.
Go to this link and review to first 3 steps. You do not need to do anything at the motor end of the shaft.
AskBud
http://www.carvewright.com/images/service/Service_instructions/CarveWright_service_replace_flexshaft_sheath.pdf

UPDATE 11/16/2009 1135 EST
Originally Posted by ruffus
I need to remove the spindle so we can get the old bull shit chuck off, I have a new machined chuck ready to go on, I keep breaking tools off in the 5/32 square hole where the flex shaft goes in. I don't want to damage anything else so the shaft needs to come out to do this properly. I removed the snap ring on top but there must be something else I'm missing.
CAN YOU HELP?
AskBud Reply
Do not, I repeat DO NOT remove the shaft or the "C" ring unless you are an expert or want to buy a new truck assembly! Here is a paper on removing the QC that you may have already seen and used.
Contact Ron Justice for better insight.
http://www.carvespot.com/forum/read.php?3,440
AskBud