ckrantz
11-14-2009, 06:16 PM
hello, my machine seems to now after 2 weeks of proper operation to now just all of a sudden have a mind of its own.
It seems that one carve is ok... the next is .250 too long.. then a retry is .125 too long... board measurements are always off by .1 .2, -.1 -.2... I seem to never get an identical length measurement. get a stretch of track sensor check errors..then they stop.
I've cleaned it out completely.. did a sensor test on the track roller, it sees the roller when i spin it. the o ring is there.
Any directions?
It seems that one carve is ok... the next is .250 too long.. then a retry is .125 too long... board measurements are always off by .1 .2, -.1 -.2... I seem to never get an identical length measurement. get a stretch of track sensor check errors..then they stop.
I've cleaned it out completely.. did a sensor test on the track roller, it sees the roller when i spin it. the o ring is there.
Any directions?