Shawnf2
11-10-2009, 07:23 PM
Just wanted to ask if anyone has ever had my problem.I'm gettin z axis stall 309 when I go to start anything project,measurement etc,the z truck jerks slightly one time like it wants to start then the error y axis doesnt move at all.I have changed the motor pack,14 pin ribbon cable,checked tension moves nice and free and smooth.
The one thing thats bugging me is I changed a controller $300 today cuz it was bad NOW THIS, wonder if something else fried when that did,not sure what all controls the z truck my only other guess is the board where the other end of the 14 pin ffc cable plugs in.I am totally lost and about to smash this thing, cant figure it out!
Shawn
The one thing thats bugging me is I changed a controller $300 today cuz it was bad NOW THIS, wonder if something else fried when that did,not sure what all controls the z truck my only other guess is the board where the other end of the 14 pin ffc cable plugs in.I am totally lost and about to smash this thing, cant figure it out!
Shawn