x axis stall error

[leethehunter]

bout fit to be tied with this machine....stripped gear....replaced...now i can't do anything because of error....when unplugging Dc motor could i have plugged it in wrong?...Lee:confused:

[Digitalwoodshop]

Try to push the sand paper belts on top and see if when you screwed down the belt plates you had the gear from the plate out of position and it is Jammed....

Or at the least.... Take off the right side and the gear cover and TRY to rotate the gear with the cover off. Bet is is jammed....

OR... Remove the bottom and look at the motor plugs...

AL

[leethehunter]

could i have plugged motor backwards as i did unplug it for fear of hurt connection while replacing gears...Lee

[Digitalwoodshop]

Yes, you could plug the connector in 180 out... It has fins on the plug... but you can.

AL