View Full Version : calibrating your machine after replacing your sand paper belts
scamp62
10-28-2009, 12:09 AM
A question about calibrating your machine after replacing your sand paper belts with the rubber set. The calibration routine requires a “ 3/8’’Jointing Bit ” well I don’t have one, and after looking for one on the CarveWright web site “ no listing “ I have to ask is this necessary ? And if it is, ware can I get one ?
dbfletcher
10-28-2009, 12:46 AM
A question about calibrating your machine after replacing your sand paper belts with the rubber set. The calibration routine requires a “ 3/8’’Jointing Bit ” well I don’t have one, and after looking for one on the CarveWright web site “ no listing “ I have to ask is this necessary ? And if it is, ware can I get one ?
This is the bit from the cw store. And as far as I am aware, it is absolutely (or equiv.) required for teh calibration routines.
http://store.carvewright.com/product.php?productid=16148&cat=251&page=2
Doug Fletcher
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.