View Full Version : x axis stall error 228
gpearson
10-27-2009, 12:57 PM
When trying to carve or measure a board I get x axis stall error 228 and board will not move.
AskBud
10-27-2009, 04:08 PM
When trying to carve or measure a board I get x axis stall error 228 and board will not move.
Things to check:
1) Board not flat (uneven surface).
2) Board binding on the "Sliding Plate" on the side away from the keyboard.
(You should always leave a small amount of play)
Not all boards have both sides that are parallel.
3) Roller pressure too tight.
AskBud
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.